Just picked up an APC 48u server rack. There were no pictures of it in the post and I did not notice until I got it home and set up, that the rack rails have threaded holes instead of square cage nut holes. I can’t seem to determine the thread size and pitch, and have a thread gauge coming. Until then, does anyone know anything about this? The people I grabbed it from had used self tapping machine screws and drove them in with an impact wrench. Is this what APC had intended, or is there some $300 proprietary screw I have to buy from them?
You must log in or register to comment.
No idea on the screw question… but the labels are off by one screw spacing. The holes that are “close” are where the U labels should change.
Yea, it’s only on that one bracket too, keen eye.
